1966-77 Ford Bronco Roll Cage Kit

1966-77 Ford Bronco Roll Cage Kit DNC 203 D and C Extreme’s Ford Bronco Roll Cage Kit will  maximize protection and is not invasive. We’ve taken our time and specifically designed this kit to provide you with as much space and comfort as possible. We have also extended our rear spreaders to give the rear passengers additional (and much needed) protection. The Ford Bronco Roll Cage was designed and test fit in an early Bronco to ensure a proper and snug fit! We have gone to great lengths to make sure that all accessories are completely operational after the cage is installed. The Ford Bronco Roll Cage allows for use of the parking brake, high beam switch, fuel gauge switch (if equipped), choke (if equipped), and access to the glove box (you can get a hand in). Will it fit in a stock early Bronco hard top? Our Ford Bronco Roll Cage fits inside the stock hard top, and it also fits soft tops designed with the same specs as the hard top. The 1966-77 Ford Bronco Roll Cage Kit is made with quality 2″ Hot Rolled Electric Welded (HREW) tube. If you don’t want anything but the best in materials we offer an upgrade to certified Drawn Over Mandrel (DOM) tube! We purchase all of our tube in 20’ lengths, cut each piece to precise measurements, bend the cage, and pre-notch all the vital joints! Basic 1966-77 Ford Bronco Roll Cage Kit includes: Main Hoop Left and Right Front Spreaders Left and Right Rear Spreaders Windshield Bar Rear Hatch Bar Dash Bar Note: Main hoop is shipped in two pieces, and is shipped with internal sleeve for reassembly. This saves about $160.00 in shipping cost. All D and C Extreme Signature Products are Made in the USA at our shop in Colorado Springs, CO! Welding and Installation Disclaimer: All cages come as kits and require assembly and welding. This product requires installation by a competent and certified welder, using high-quality welding equipment and supplies. If you are not a qualified welder you should hire a professional/certified welder from your area.  This product should only be welded with a minimum 220v/175a MIG Welder and .035 wire. Minor trimming may be needed for exact fitment to customer vehicles. D and C Extreme has made every effort to make cage kits strong and easy to install. However, we cannot control the installation process of our cages and therefore, D and C Extreme cannot and will not guarantee the performance of any cage kit. Drivers of lifted or modified vehicles need to exercise extreme caution when operating said vehicle. D and C Extreme Industries Product Disclaimer: Because of their intended usage, the manufacturer makes no warranties whatsoever, express or implied, oral or written, to purchasers of their products regarding performance, safety, fit, merchantability, or length of service. Purchasers are responsible for selection of proper goods and must rely on their own skill or judgement that such goods are suitable for purchasers’ application. Applications: 1966 – 1977 Ford Bronco