Our weld on D-Ring/Shackle mounts are 3″ x 1″, with a 7/8″ hole, for use with a 3/4″ pin, machined from solid 1″ bar stock, which provides very tight tolerances, unlike similar Plasma or Flame cut mounts. Our mounts have a machined hole to fit the D-ring pin much tighter that a cut mount. This keeps the Shackle from bouncing and rattling around in the hole. These mounts are a full 1″ thick. This helps keep the pin from trying to twist sideways. The mount was designed to fit on the face of at least 3″ stock. We use these mounts on our Signature Series, front bumpers, which is a 4″ x 6″ rectangle tube, as you can see in the photo below. Unlike a lot of other mounts on the market, our mounts are 1″ thick. As a result, this makes for a much stronger mount. Not only does it give you more surface area for welding, it also spreads the load area out more than a 1/2″ or 3/4″ mount. These mounts are Sold Each! Please order 2 of them if you need a pair. These are solid billet weld on mounts 3″ X 1″ D-Ring Mounts Shown on Bronco Front BumperD and C Extreme Ind. 3″ X 1″ D-Ring Mount Shown on Scout 80/800 Front Bumper D-Ring/Shackle Mount3″ X 1″ With 7/8″ Hole for use with 3/4″ pin D-Ring/Shackle Mount3″ X 1″ With 7/8″ Hole for use with 3/4″ pin










